Registered: April 2006 Location: Uppsala, Kingdom of Sweden Posts: 398
Semi finished hammer. Missing depth of big inner dia. and sear slot. Also missing the hole and groove for the pivot pin of the sear. That measure can be taken from either side to the rim of the pivot hole. Then I need the diameter of the pivot hole and the small groove and the depth of the small groove.
The sear could be photocopied alongside a ruler (metric or inches) and I will model from there with the aid of some more caliper measurements. Tha'ts about it I think.
· Date: Fri February 10, 2012 · Views: 218 · Filesize: 15.4kb · Dimensions: 347 x 391 ·