Empire Sniper Mamba Trigger & Other Upgrades

[Dirklax39]

Anyone have any details on where to source a sniper ID mamba trigger?

I'm also on PBN, FB Groups, & eBay, but haven't had ANY luck. What's the going rate for these when they are available?

Also, if you like taking about this stuff I'd love to hear what your favorite sniper upp's are (laz valve, CCM spring kit, wgp reg seat... etc).

Thanks! (PFA)

[JohnB]

Good luck, I have been looking for one for a few years. They don’t come up often, typically already on a marker.

sniper set up - heavy hammer kit and Id pump kit. The id pump kit is critical for ease of maintenance on these markers imo.

[ramagupa]

Ive been told the slice karni adapter will fit a sniper to use with ccm handles. Havent tried it but wanted to.

As for upgrades, i agree the heavy hammer is a must. Ive toyed with various valves, i think my best results have been with the ccm ss25 valve (i dont like the laz for pump)

[Dirklax39]

Actively looking for a FULLY UPGRADED empire sniper! ramagupa - is the ccm ss25 here just plug and play? Why do you like it better than the stock empire valve? Also, is this the right one and all you need? https://store.chipleymachine.com/val...d-valve-stems/

[ramagupa]

Yes ccm’s ss25 valve should be plug and play, as are most other 11/16 valves. The ccm should lower operating pressure and im pretty sure their valves use an oring on the stem which acts as the seal.

the stock valve is like a standard wgp valve where the delrin/plastic is the cupseal. So the ccm would also be a longevity upgrade as you would only need to swap orings if the valve starts to leak.

Might want to email/call ccm and ask if the oring is easily swapped on the valve stem just to confirm

[ramagupa]

Actually you may also wanna be careful using the ccm valve spring. As it may be too small for the perch of the body (the place where the spring sits behind valve)