Does anyone have the dimensions for a single rod undercocking kit for a phantom? I'm trying to make a novelty pump handle for my phantom but obtaining the dimensions is difficult and I don't want it to bind. I've attempted it but I'm pretty certain my measurements were off.
-
I just modeled a single rod UC handle the other day. Do you use Fusion360, by chance?Rainmaker's feedback: https://www.mcarterbrown.com/forum/b...maker-feedback
-
Occasionally. Haven't used it in a while but should still have an account there.Comment
-
Disclaimer: This is how I personally measured the dimensions of a Phantom UC single rod kit, and is not official documentation.
Rainmaker's feedback: https://www.mcarterbrown.com/forum/b...maker-feedbackComment
-
Awesome, thanks! If you haven't noticed any issues I'll default to that. I had .313 and .197 instead if .352 and .25, and I'm not super happy with my method I used of using a dry erase maker to stamp the pattern onto a piece of paper to measure it.
Thanks a ton for the help!Comment
-
Sure thing, broski.
It didn't seem to bind at all, pumped smoothly.
I put masking tape down the center of the holes and used a caliper to measure from one tape edge to the other. It wasn't perfect but it got me really close. Then I printed a cross section (only like 20 print layers) to check against the original pump handle I had on hand, and made minor adjustments.Rainmaker's feedback: https://www.mcarterbrown.com/forum/b...maker-feedbackComment
-
Also, while we are talking about it, here's the dims I used for Dual rod UC handle:
Rainmaker's feedback: https://www.mcarterbrown.com/forum/b...maker-feedbackComment
Comment