insert a makeshift detent in the left side of a tippmann 98?

[COMMANDERBOND]

the feed side is jb welded closed

[lhamilton1807]

I’m modifying a Carver One to be Magfed. I’m basing my LokBolt & detent design on this. It fits through the stock feed neck hole.
I’m sure it could be modified to fit a T98.

[COMMANDERBOND]

i am aware of these-just never thought of it. a pretty good simple solution. thanks

[DieManInTheRough]

The tippmann stormer elites use a detent/ball latch that seats into the feed tube hole much like a powerfeed plug. Would be easy to fab or model and print if you have access.

[Jonnydread]

I have a magfed Tippmann copy and due to the paint being fed from the bottom they have a standard Tippmann style detent in the top of the receiver.

[BrickHaus]

Iirc, you have a good pocket in the top of the body.

In that area that is the sight rail, and cocking rod. Can you carefully cut the pocket up top in each half?

[COMMANDERBOND]

iI had some beate marker with those style detents and sold them. was an mistake was saving for just that putpose.

thank you for the advice.

[Ecapnation]

Tap the body for a cocker style detent?

[COB]

You could try a wire detent like the BE Raptor through the plug filling the original feed port.

[COMMANDERBOND]

Its funny how the brain works - by asking the question i came up with a possibility.

[COMMANDERBOND]

I am looking for an easy way to insert a makeshift detent in the left side of a tippmann 98. This is for a custom that feeds from the bottom - right where the detant sits
there may be the possibility of detent on the tup