-
-
-
They have a few for sale, not a bad idea to make a lamp out of your dead tanks for the man cave.Feedback: https://www.mcarterbrown.com/forum/b...ova-s-feedback
WTB: ICD stuff, single trigger electro frames, Gloss lime and purple parts, smoke hoppersComment
-
Yeah thats kinda cool.Comment
-
I'm keeping an old CP stubby for just this reason, but need a man cave first. I don't think a table lamp could survive my garage/ shop. Mostly for lack of table space.Feedback
www.PhrameworkDesigns.com < Nelspot, Sterling, and Phantom parts, plus the occasional big project.Comment
-
I've got a gorilla and a few old co2 tanks, I've saved for the same purpose. The DIY lamp kits and base mounts are a rabbit hole on the amazon.
Comment
-
the carbon fiber tanks are a pain to cut, I had to sharpen my cutoff tool 2 or 3 times to go through the one i cut for my freak caseLove my brass ... Love my SSR ... Hard choices ...
XEMON's phantom double sided feed
Keep your ATS going: Project rATS 2.0
My FeedbackComment
-
So do you have to remove the lamp parts to get it hydro tested?eBay 2047+/0- Feedback
PBNation 182+/0- Feedback
Old M. Carter Brown 142+/0- Feedback
New M. Carter Brown 6+/0- Feedback
Over 2300 all positive transaction feedback.
THIS HOUSEHOLD IS SURVIVING CANCER!Comment
-
I make these any time I get my grubby hands on an old tank. I usually just have to drill a small hole in the bottom to pass the rod through. I go to Goodwill and buy a $7 lamp that has cool parts I can use and just swap them over. I give them out as gifts.Comment
-
Would be really cool if the gage were the off/on switch.Comment
- Welcome to MCB! We are the most popular and active paintball forum found on the internet! Thank you for stopping by. If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment