Where to buy Parts for STO Slide Frame

[shooter311]

Thanks all. forumreader hooked me up with a spring and bearing. I contacted ID and they said theirs might work, but it was $9 shipping for the $3 parts. Thanks again.

[iamthelazerviking]

Bacci has some stuff.

Ball bearing:

https://www.baccipaintball.com/she427.html

And this page has a few different options for the spring:

https://www.baccipaintball.com/catal...=safety+spring

[lew]

Ditto on "omit the safety". None of the dozen Cockers I've had have had a safety, and it's never been an issue.

[BrickHaus]

Autococker parts.com, or maybe palmers. I know they have safety balls and springs fpr sheridans. Are they the same parts?

[shooter311]

I didn't see anything on there.

[iamthelazerviking]

Check autocockerparts.com as well, if you haven't already. I haven't looked, but figure that could be a good source

[shooter311]

Awesome, I'll e-mail ID and see if they know if it fits first. I'd prefer to give them the business if I can. Which means I'll go to buy this one part and end up spending another $500 on stuff I really don't need there.

[Grendel]

https://www.ebay.com/itm/Safety-BALL...-/174148271498

Inceptions may work also:
https://www.inceptiondesigns.com/SAF...p/ifp-1014.htm

or just find a small ball bearing the fits and hardware store and browse the spring drawers.

[Ecapnation]

I recently went to put my STO slide frame on my pump, and all the parts were on my tech mat, when my 3 yo pulled it down on the floor. I found everything except for the tiny spring and ball bearing that goes to the safety. Where can I find replacements? I assume I could find the parts from non-paintball sources too, but I have no idea what sizes I need.

Also, I don't want to just remove the safety. I like to set up the pump so it shoots with the safety on so it is a super short pull.

I hope someone can help, thanks!

More trouble then it's worth just omit the safety

[shooter311]

I recently went to put my STO slide frame on my pump, and all the parts were on my tech mat, when my 3 yo pulled it down on the floor. I found everything except for the tiny spring and ball bearing that goes to the safety. Where can I find replacements? I assume I could find the parts from non-paintball sources too, but I have no idea what sizes I need.

Also, I don't want to just remove the safety. I like to set up the pump so it shoots with the safety on so it is a super short pull.

I hope someone can help, thanks!