Revs9k's Collection of Paint Throwers

[Revs9k]

My Autocockers


System X Vengeance Attitude



WGP 2K1 STO


99 Kapp Classic




My Pump

2k2 Black Magic







My Automag




My Blowbacks


AKA Spyder LP



Spyder Imagine LP 290fps @ 275PSI

[lew]

Dat 'Mag.🤑

Nice pile o' markers.

[Revs9k]

Updating the collection Here

The $20 Dollar Black Magic

SCI-FI'd Shoebox


Sovereign 1 Project I wish I had the original Matching barrel for this.........


Super Starter Piranha Build





I added this picture as its My Old mans Imagine, He bought this brand new back around 2001. It was to do 1v1's with me in the backyard.... He didn't do all that well. His excuse was that he didn't want to hurt my "young and tender feelings" Typical Dad response...

[Dusty Bottoms]

That little Kapp setup is sweet!

[Revs9k]

Hey thanks! Its a really tight package with the Docs Machine Tanto on it. You can keep it really tight on corners. Ive thought about converting it back to a mech though. I have all the original stuff and feel that's the way it was intended to be.

[440SUPERCOMMANDO]

o, that imagine is KLEEN!

[Revs9k]

Thanks! I like it alot .Its currently torn down awaiting a new black imagine body to match the rest of the polished black pieces. Cant wait to get it together and tune it up again.

[Revs9k]

Updated the stable

[Pumpytrilly1]

Mind sharing internals on the spyders

[Revs9k]

The aka'd spyder has aka valve and lightning bolt with a worked over hammer that's been cupped and polished .

The black Imagine has a NDZ valve with a Shocktech bolt and a cupped and polished hammer as well.The front block is a 32 degrees high flow unit

[Pumpytrilly1]

I tried googling it. What is a cupped hammer?

Thanks for sharing. I just picked up a spyder amg I would like to mod.

[Revs9k]

https://web.archive.org/web/20080205054719/https://www.ottersccustoms.com/project.html

Here's a great resource for modding Spyders that has proved itself very valuable. It lists many of the modifications that I have done Including a picture of a cupped striker part of the way down the page.The striker was made by dark horizons out of titanium but you can see that the face of the hammer has been "cupped" This can help aid in getting the marker to re-cock. I performed this mod on a lathe after annealing the hammer to make it soft,then heating it again in a heat treat furnace and quenching the hammer to harden it again. Its not really a necessary modification but with going low pressure every little bit helps. An AMG should be good to go with a valve and a Palmer's female stabilizer to start. There are a lot of members on the board here that are WAYYYY better at modding Spyders than myself. Off the top of my head GanonsGrin , ScottieB ,tarsun2 and I am sure I'm forgetting others that are also extremely helpful people with a wealth of knowledge on modding them.