Has anyone tried one of these on a halfblock autococker? I am building a halfblock autococker and was thinking that i might run with a hush bolt if it would work. I imagine that the bolt may be to large, small, not long enough or the valve does not line up. While on the subject are these any better worse or otherwise different than something from say Staunchy?
-
Tech-T? I've wondered as well. I have a SM-1 and was looking for options other than custom.... -
Yeah the Techt bolt on looks alone i think it might work but i have been know to be wrong more often than not.Comment
-
It all depend on the halfblock dimension you used, back block size and hammer groove. Not everyone cut them the same way.
I am learning it the hard way, have 3 halfblock hammer with different groove length (from 0.75" to 1") and some wont engage in the sear or the bolt is way pass the breach when it engaged. Also the bolt in the backblock need to align the air passage hole.
So I am currentlu making a custom 3d print backblock to make everything fit
If you want to be sure you would need someone that have one to take some measurement first (from bolt tip to pin center and from air passage to bolt pin center).Comment
-
I have a half blocked autococker and a Ressurection The Ressurection bolt needs to be cut about 2mm basically the front o-ring slot (stock bolt) needs to be cut off to fit in a midblock/half block autococker. It's too long and won't feed paint down tube. I cut mine and it works alright. But at that point I would go get a half block bolt like inception designs trident. But this was only issue Ive noticed with my half block. Idk if others are different.Comment
Comment