Brass Eagle Nightmare SB, that might wish it was a Comp, on the Bay

[wthomas333]

Check out the last post in this thread. There are some links posted for valve and pierce pin assembly parts, including the seal for the 12g.

https://www.mcarterbrown.com/forum/paintball-news-aa/the-armory/brass-eagle/235265-nightmare-disassembly-question

[Limywidget]

I sent him a message. Thanks!

3d printed feed gate would be something....ha!

[Carp]

Have you tried a COB ? ...🤔 Heck, for a feed plug, I'd almost look into some kind of 3D printed feedgate thingy.😉

[Limywidget]

First you build a time machine.....

It bacci paintball doesn't have the hard parts happy hunting!

Ha! I have looked for a while for the Nightmare. I may just 3d print one and call it a day. I tried Bacci already.

[Ecapnation]

Any ideas on where to find those items and a new charging seal for the 12g? 😉

First you build a time machine.....

It bacci paintball doesn't have the hard parts happy hunting!

[Limywidget]

That's nice looking. Just need a front feed plug and some orings/seals.

Any ideas on where to find those items and a new charging seal for the 12g? 😉

[Carp]

It says $157.50 +shipping. 😉

[dartamon]

How much did it go for?

[RuleOfSines]

Good point, yes they did

[Number six]

Didn't Comps also have a feedneck?

[RuleOfSines]

Technically not a Comp, just a SB. Comps have the cutout for quick 12 gram changes.

[Carp]

That's nice looking. Just need a front feed plug and some orings/seals.

[MrKittyCatMeowFace]

.