instagram takipci satin al - instagram takipci satin al mobil odeme - takipci satin al

bahis siteleri - deneme bonusu - casino siteleri

bahis siteleri - kacak bahis - canli bahis

goldenbahis - makrobet - cepbahis

cratosslot - cratosslot giris - cratosslot

Announcement

Collapse
No announcement yet.

phantom double sided feed (3D printed) - Interest thread

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #16
    Ok, broke one on "destructive strength test" today. Only got a small part of the process in video (the end where it break) ill post it if i can figure out how ...
    I knew the weakest point is where the mounting bolt is, so this is where i shot it.
    All the shots were at point blank directly into the center of the feed block, from about 4-6" away.
    It took 23 direct shot before it gave ... this is a lot more than i expected.

    Here is my "setup":


    "Action shot":


    And the break:


    Love my brass ... Love my SSR ... Hard choices ...

    looking for red/black or blue/silver phantom.
    XEMON's phantom double sided feed


    Keep your ATS going: Project rATS 2.0
    My Feedback

    Comment


    • Grendel

      Grendel

      commented
      Editing a comment
      Is there enough meat at that point to print as two separate pieces and connect with pins and adhesive for added strength?

    #17
    You should shove the next one in the freezer first for round 2…for science!

    My first one broke taking a close range hit playing in the cold.


    23 shots is impressive though!
    JeepDVLZ45's Feedback

    Comment


    • XEMON

      XEMON

      commented
      Editing a comment
      I might try it if I get a wired print I can't use ... Didn't though about the temperature ...maybe I should have added it? I'm in California, so it s about 95 today

    #18
    i have question will this not make this true stock class now since have extra stick feed on gun.

    Comment


    • JeepDVLZ45

      JeepDVLZ45

      commented
      Editing a comment
      We should be able to keep it within SC 2.0 rules.

      When I ran my original APOC feed (not spring Fed) with a 15 round tube, it held 23 rounds between front and rear combined. I ran an 8” Deadly winds barrel and. 15 round CCI front. So it was just outside he StockClass 2.0 rules….

      however, with my current setup, I’m running a freak back with Doc’s tip. I’ll need to shorten my front tube a bit to make it work. I won’t run stick feed rear, I’ll try to stick with something fixed to keep me compliant

      I’m hoping that puts me to the 20 round mark to keep it within SC 2.0. If I have to, I’ll put a spacer in.

    #19
    Ok, some updates!

    Got some gloss carbon tube to try out ...
    And should have the last of the hardware tomorrow.


    Click image for larger version

Name:	PXL_20210721_034712623.jpg
Views:	65
Size:	1.55 MB
ID:	152859
    Love my brass ... Love my SSR ... Hard choices ...

    looking for red/black or blue/silver phantom.
    XEMON's phantom double sided feed


    Keep your ATS going: Project rATS 2.0
    My Feedback

    Comment

Working...
X