View Single Post
Old 01-13-2010, 05:56 PM   #184 (permalink)
dukie
more gooder
 
dukie's Avatar
 
Join Date: Apr 2008
Location: Kitchener, Ontario

Fan of EMR
CCM Fan
CCI Phantom Fan
Finished off the feedtubes this morning:



I figured I would program the cut for the ramp on the ball feed/valve chamber plug. That didn't work out very well. I got a grand total of 2 cut in 4 hours today. Talk about a cluster f***. However programmed the interface on the machine has never taken a geometry class obviously. REQUIRED over definition of positions causes a lot of grief.

But its sorted now and I can just let them run while I drill and tap the mounting holes on the same piece. One good thing is I will never have to develope these programs again. No pain no gain I guess lol
dukie is offline   Reply With Quote