View Single Post
Old 11-05-2010, 06:19 PM   #7 (permalink)
dundadun
Boom. Yummy
 
dundadun's Avatar
 
Join Date: Jul 2007
Location: SoCal

Brass and Wood Fan
Kilt Club
Quote:
Originally Posted by ITSPB-Rogue View Post
That would be cool but brings in a new level of complexity to machining it, also requires a larger block of material to start with.
that's if it slid "into" the feedtube hole, do you think it could feed fine without sliding into that hole and used the same plunger? If it didn't slid into the hole, and could use an extended valve bolt to secure it like you said, it could be simpler to make. A lot of 'if's' though.

I'm trying to think of other ways to have the feedtube reload as well, but can't think of anything yet.
dundadun is offline   Reply With Quote