View Single Post
Old 11-13-2007, 09:27 PM   #1 (permalink)
AKA Baby Ollie
Marmaduke's Avatar
Join Date: Oct 2006
Location: Washington
Send a message via AIM to Marmaduke

Need WAS help on Excal.

I just installed my new WAS board on my Excal. Solenoid for firing doesn't want to go. It will cycle just fine though.

I don't have eyes. The LED tells me it's in eye bypass mode. I don't have eyes so I assume this is correct.

I did have a soldering job done on the wires that connect the solenoid to the board. Could that have anything to do with the problem? They work fine on the Nelson board. Guy who did it is a gun tech.

Any help would be appreciated.


PBN Feedback 11/0/0
MCB Feedback 8/0/0
A5OG Feedback 12/0/0
eBay Feedback 5/0/0
Marmaduke is offline   Reply With Quote