View Single Post
Old 11-12-2012, 03:31 PM   #7 (permalink)
Millar156's Avatar
Join Date: Apr 2009
Location: Patton, PA

I have an idea but I've never tried it to see it it would work.

You could get a rubber bushing(like a sway arm linkage bushing, something close to the ID of the feed neck), 2 washers, a piece of all thread, and 2 nuts.

Run the all thread through the center of the bushing with nuts and washers on either side. Tighten the nut up enough to expand the bushing so it's tight inside the feed tube and use that to pull it out. Not sure if that would make enough friction to do the job but I've used similar devices to seal up pipe.

Now I want to try this out to see if I'm just an idiot...
It is not the critic who counts, not the man who points out how the strong man stumbled, or where the doer of deeds could have done better. The credit belongs to the man who is actually in the arena; whose face is marred by the dust and sweat and blood; who strives valiantly; who errs and comes short again and again; who knows the great enthusiasms, the great devotions and spends himself in a worthy course; who at the best, knows in the end the triumph of high achievement, and who, at worst, if he fails, at least fails while daring greatly; so that his place shall never be with those cold and timid souls who know neither victory or defeat. - Theodore Roosevelt
Millar156 is offline   Reply With Quote