View Single Post
Old 01-15-2013, 09:10 PM   #2229 (permalink)
more gooder
dukie's Avatar
Join Date: Apr 2008
Location: Kitchener, Ontario

Fan of EMR
Get rid of the threaded holes in the side and jut put them in the top. gets you the same result with 1 less setup and operation. unless you were silly and put them on both sides. then you save 2 setups and operations lol.

Profiling the top really isnt a big deal unless you are trying to make it on a manual mill. it goes slower than just facing but its reasonably quick.

Other than the double angle cutter for the inside i could make that right now.
dukie is offline   Reply With Quote