View Single Post
Old 07-15-2014, 04:20 PM   #174 (permalink)
Active Member
Join Date: Apr 2011
Location: Finland

I think you should add this picture:

to the front page. I remembered reading that a while back, but now when I was getting around to actually doing it I had to spend some time looking for it.

Anyway. Now I just want to make sure before cutting (measure once, cut twice etc..), the rear part needs to be threaded afterwards (also on the newest kits)? and what benefit might I see from swapping the rear(est) banjo for a QEV (I also have the mech kit)?
Originally Posted by Crimson Death View Post
This is MCB we have higher standards than that! Go post that drivel on PBN!
devlin is offline   Reply With Quote