View Single Post
Old 12-07-2017, 07:39 AM   #7 (permalink)
New member
Join Date: Nov 2013
Location: Montreal, Qc, Canada

Palmer's/cocker advice needed

The best way i found to build a reg pressure tester is to use an old remote or an standard ASA with two port
On one side i fitted a remote slide check for quick degas and on the other side i put a gauge mounted on a quick connect. The quick connect allow me to change different pressure gauge depending on the max pressure i want to read (i use a 1kpsi, 500psi and 300psi) i know a bigger 2.5" gauge for better accuracy but i did not had one when i built this

If you replace a reg in your marker you just have to remove and check pressure then ajust the new one to the same pressure

The pressure your marker need depend on the valve and spring you use in your setup but 350psi should work
Alexndl is offline   Reply With Quote