View Single Post
Old 05-16-2018, 02:57 PM   #8 (permalink)
Rainmaker
Previously blasdgag
 
Rainmaker's Avatar
 
Join Date: Dec 2017
Location: Huntsville, AL

Removing a support like that which would be under the feed tube seat - not bad. Removing a support from the feed gate groove - a bit more of a PIA. Due to it being a small groove and surrounded by solid on three sides. The other thing that happens with supports is that the first few solid layers of your object above the support can have a tendency be kinda "loose", and layer adhesion suffers a little in that spot. Not always though.
__________________
Dangerous Power G3
PE Etek 3 AM
JT ER2 with 3D printed mods
Rainmaker's Feedback
Rainmaker is offline   Reply With Quote