View Single Post
Old 06-13-2018, 09:09 AM   #1 (permalink)
Previously blasdgag
Rainmaker's Avatar
Join Date: Dec 2017
Location: Huntsville, AL

What did you 3D print today?

In the spirit of some of the other show-and-tell threads on here, post up your most recent prints (and print settings too!!), paintball related or not (which may take this a bit OT at times, but oh well).

To kick it off, here's what I printed last night:

A "wood" tile for Settlers of Catan, the first print off many to make a fully printed set of tiles. Not my design though, it can be found here along with all the other pieces:

Settings: layer height 0.2mm, infill 20%, speed 35mm/s, printed with 5mm brim for adhesion.
Phinally a Phantom owner!
(also ER2, G3, Kaos, 98C)
Rainmaker's Feedback
Rainmaker is offline   Reply With Quote