View Single Post
Old 08-03-2018, 07:44 AM   #14 (permalink)
Rainmaker
MCB Member
 
Rainmaker's Avatar
 
Join Date: Dec 2017
Location: Huntsville, AL

CCI Phantom Fan
Finally getting consistent prints with PETG. Woke up to see this sweetness on my bed...
IMG_3803.JPG
What ended up working for me was 230C, on blue tape, lightly sanded, with glue stick, combing off, coasting off, reaction 1.5mm @ 45mm/s, flow 98%, first layer line width 98%, first layer speed 30mm/s, regular speed 60mm/s, travel 80mm/s. Also I have a fan on my hot end heart sink and one pointed at my print bed - I put fan speed at 100% but disconnected the fan cooling the print, and left the one in the heat sink running full speed (prevent clogs)
__________________
Phinally a Phantom owner!
(also ER2, G3, Kaos, 98C)
Rainmaker's Feedback
Rainmaker is online now   Reply With Quote