| ||Thread Tools||Search this Thread|
|05-02-2019, 10:44 PM||#11 (permalink)|
Join Date: Mar 2011
Location: Vacaville, CA
I've tried to put an old VL gravity feed lid onto a newer revy, with the clear hard plastic lid, and it didn't fit. If I remember right the old lid was bigger.
Cockers and Mag
Dragun t1, Project salvo, cheap blowbacks
MQ2 valve, T-board
3d Printed Mag Y-Frame
Last edited by Macdave06; 05-02-2019 at 10:52 PM.
|06-15-2019, 07:38 PM||#12 (permalink)|
Join Date: Mar 2006
Location: East Tawas, MI
I have made some progress on this since he messaged me last night. on my 2nd attempt I got a nice fit on the Revvy I have in my possession.
I tried the lid on a vl 200 and it was just a bit bigger then the VL200 lid. I am not sure if this is across the board, but the few VL200 I tried all seemed to fit about or didn't fit rather, about the same.
Mcarterbrown - https://www.mcarterbrown.com/forums/...-feedback.html
|06-15-2019, 10:29 PM||#14 (permalink)|
Join Date: May 2009
Location: Yuba Co.,CA
I just did the swap. It worked fine but I noticed the clear revy lid didn't quite fit on the vl200. Some minor shaving would probably make it work. So it looks like there is some minor variances between loaders and I'm sure wear from use even is a factor. The revy spring seems to work best on the lid also.
|Thread Tools||Search this Thread|