-   Air Gun Designs (
-   -   Mag Go Boom (

TrracerAce 06-10-2012 02:06 PM

Mag Go Boom
Specifics: Classic Valve, Level 7 bolt. Nothing fancy. Running HPA.

Never thought I'd be saying this but my Mag a'splode.

Basically after 4 years of storage, I oiled 'er up, took some test shots and then went to Operation Massengrab. First game had a couple issues with the regulator leaking at random, nothing serious.

Cronying for the second game saw the regulator go haywire, leaking badly, then it'd start getting ridiculous dwell (went from cronying at 250ish to 485) which managed to cause the on/off assembly to not seal anymore, leaking the entire tank out the trigger assembly. Pulling it apart and re-oiling it didn't do anything to fix the problem.

So, uh... how screwed am I? I'm thinking the cheapest way to fix this is to buy a used Classic Mag and swap the guts because troubleshooting it looks like everything with a valve or seal got fried when the regulator stopped regulating and basically matched pressure with the HPA tank.

superman 06-10-2012 02:21 PM

i would say buy and oring kit and a reg piston.and just rebuild the on/off and replace the reg piston. you should be fine.

Ando 06-10-2012 04:47 PM

Just rebuild it. You'll be fine.

Justus 06-10-2012 10:57 PM

As mentioned, it sounds like a reg piston problem. A new one is $18 from AGD. Also pick up a pack of reg seats and any of the other o-rings that seem to be shot.

Doing that should be almost just as cheap as finding and buying a new classic valve, and you'll have the peace of mind that all your internals are brand new and not on the verge of letting out again.

henchman 06-11-2012 12:21 AM

Or just send it in to AGD.
Then youll get it back working for sure.

All times are GMT -4. The time now is 10:05 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC