Custom

[Macdave06]

Looking to take some weight out of this ZXS.
What I'm thinking is basically copying this out of delrin except for the part that contacts the lever for the valve. Maybe a 3 piece with a stainless sleeve for the contact point. I will be using a lighter return spring as well as valve spring to compensate for the loss in mass.

Any input is appreciated.1549822664039.jpeg1549822694047.jpeg1549822736382.jpeg1549822758055.jpeg

[Macdave06]

Might have something lined up.20190212_195619.jpeg

[The_Hyren]

Cool idea but Id be worried about the delrin's longevity where it contacts the valve lever. Maybe just the rear half would work best?

[Macdave06]

There won't be any delrin in contact with the valve lever. My original plan was to cut down the original bolt and sleeve either end in delrin. Frmspec got it and figured he could make a new bolt with an insert for the contact area. Rather than chancing ruining a hard to find part.

[The_Hyren]

I gotcha, I misunderstood. Would be a decent kick reduction.