-   AKA (
-   -   Trigger settings/options (

WholemealDrop 06-13-2013 02:16 AM

Trigger settings/options
Purchased an '03 Viking with a JMJ Razor trigger. Found it way to sensitive and light to my liking. (I tilted the gun up to adjust the reg and it fired just from the trigger falling back on the microswitch) Any way to stiffen the pull just a little bit? I replaced the microswitch from a 35g to an 80g pull and that helped a tiny bit but the trigger still just floats freely. A friend recommend a pen spring but since stock (to my knowledge) the Viking didn't use a spring I can't think of where I would put it. Thoughts?

tolar250 06-13-2013 08:11 AM

you can put a spring in a jmj razor blade, i just did one this week. you will have to remove the trigger frame and tray from the gun then remove the tray from the trigger frame. in the top of the trigger towards the back of the trigger there should be a hole for a spring.

to me it sounds like there is a lot of travel in your trigger. i have never had that happen on any of my aka's using a jmj razor trigger and the stock 25 gram switch, and they did not have return springs. but i set up my trigger pull short.

WholemealDrop 06-22-2013 04:44 PM

Really doesn't feel like very much travel. Just as short as my Rapper but doesn't have a trigger spring. I'll have to tear apart my frame and look for this hole, cut down a pen spring and see how it goes.

WholemealDrop 06-25-2013 12:10 AM

Dropped in a cut down pen spring and feels pretty snappy. Not quite as nice as my Rapper but definitely better than nothing.

All times are GMT -4. The time now is 02:49 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC