mag frame on a cocker body?
the old school metal mag frames on a pre 99-2k cocker body?
can the trigger in the mag frame be switched to slider parts without modification? will the frame match up to the cocking lug slot and frame screw holes?
thanks for any info!
Holes will match up and I think you can switch the guts out for slider bits.
It might be easyer to just get a complete slider frame tough...
Right, but.....why? I've always kinda disliked the old Mag frames
the why: i have an old mini body that i have put a wwa ultra pump kit on. works great except for this: the sliders i have will not allow me to use my 3.5 oz tank-the burst disc assembly hits the front of the trigger guard and won't allow it to be screwed in all the way
i'm looking for a way to get the clearance without having to get a new frame or tank, unless there are burst discs available with a smaller profile.
thanks for the info!
Older CO2 tanks had busrt disk nuts that were flush with the valve. They went to the current style so if it blew the CO2 jet is dispersed out the 3 small holes instead of 1 big jet shooting straight out from the tank.
So basically you could cut the head off of the burst disk nut and slot it for a screwdriver and have one like the old style flush ones.
The real advantage of the mag frame on a cocker body is putting Intelliframes on Autocockers, using Morlock boards. It's a good way to make a E-cocker(admittedly, very expensive compared to the WGP kit).
it was just too easy of a solution for me to figure out.
you cant just drop slider parts into a mag frame, the amount of work would out cost just buying a new frame,
you can how ever use the mag frame for a sniper by drilling a hole for the old cocker sear.
|All times are GMT -4. The time now is 03:57 AM.|
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC