| ||Thread Tools||Search this Thread|
|09-23-2017, 12:07 PM||#1 (permalink)|
Cheap a$$ gunslinger
Join Date: Jul 2010
Location: Lexington, SC
Ok well i picked up a plastic slide frame for my trilogy, it didnt come with springs so i used the sear spring out of my trilly frame and a pen spring for the trigger return spring, i filed down the valve retaining screw but the trigger is really mushy and has a slow return, it isnt like this until bolted on the marker, should i try sanding down the top of the plate or is it a spring issue
Even enemies can show respect
STOCK CLASS-the Jedi way of paintball
|09-23-2017, 12:59 PM||#2 (permalink)|
Does anyone read this?
Join Date: Jul 2006
Location: Jordan Station, Ontario, Canada
The trigger plate is binding on the gun body.
You can try adding a little grease to the part of the body that the trigger plate rides on, see if that helps... but make sure there's nothing sticking out from the body that's binding against the top of the plate, like the valve setscrew.
If all else fails, try have the frame screws on the loose side rather than cranked down.
Last edited by Jordan; 09-23-2017 at 01:54 PM.
|09-23-2017, 07:17 PM||#3 (permalink)|
Join Date: Jun 2009
Location: Orem, UT
I noticed this problem with one of my trilogies; it went away when I pulled the timing rod out. What this told me was that the geometry of the frame was slightly different and was causing alignment issues with the timing rod. I haven't fiddled with it enough to find a good fix for that, though. The gun is going to be a pump anyway so I didn't care too much.
|Thread Tools||Search this Thread|