-   CCI (
-   -   Drop out & stock class feed ?'s (

dundadun 03-10-2008 07:04 PM

Drop out & stock class feed ?'s
Could I see some close ups of drop out valves and stock feeds/one piece feeds? How much of a gap is everyone getting? Or are you trimming the feed gates?
Also is there any other "plugs" that fit the threading on the drop out valve threads?


taco 03-10-2008 07:32 PM

get one of these feedblocks if you can find one hehe. just stab your ten round tube in and you're good 2 go

dundadun 03-10-2008 07:36 PM

that's the way i currently have it, but with the stock cci feed block
looking into/piecing together a second setup now

Ir0nExpress 03-10-2008 10:43 PM

For dropout valves, the feedgate needs to be dremeled for a fine fit, otherwise it goes in kinda crooked.

dundadun 03-10-2008 10:47 PM

and for one piece feeds i'de have to do that to more than just the speedgate huh? to the bottom of the feedtube itself

xkpxfatassxx 03-10-2008 11:02 PM

It shouldn't bother you. Just think of it as less rocking.

Ir0nExpress 03-10-2008 11:11 PM

It looks gross when the feedtube is ajar, I hate that haha

dundadun 03-11-2008 05:25 AM

yeah i'd rather have it flush, looks better, and I'd be less worried about the lone screw that holds it on in case of a bump

Schmitti 03-11-2008 10:38 AM

The tube would fall out before the screw holding the feed block in breaks.

Remember the feed tube (aluminum) has light threads that lightly grab the delrin of the feedblock. While it holds the tube in, there is room for play so that things don't break during use.


dundadun 03-11-2008 05:26 PM

and for one piece feeds? that's what im worried about

All times are GMT -4. The time now is 08:24 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC