-   CCM (
-   -   Cam retaining pin question (

BIG BOB 08-03-2013 03:28 PM

Cam retaining pin question
So I just got a new 86 frame and the cam retaining pin from my thin frame is to tall, should I try and file it down or talk to ccm about getting a shorter one?

hoov7888 08-03-2013 03:40 PM

That would definitely work but I'd suggest getting a new pin so u don't have a missing pin on your 45.

A fellow mcber told me a guitar wire or paperclip, ect. Would work just fine until you can get one shipped from ccm

BIG BOB 08-03-2013 04:06 PM

Will give it a try after work. Thanks

CCMachinist 08-03-2013 11:29 PM

IIR the cam pins are all the same length.

There is not a longer pin in the shop.

There could be polishing compound in the small pin hole or bead blast in the hole.

we clean the holes out with a 1/16" drill

If you don't have a small drill a small paper clip may help clean it out.

Also most hardware shops carry 1/16" drills probably 2 or 3 bucks.

If that is not the issue call the shop on Monday.

BIG BOB 08-04-2013 12:11 AM

Sounds good. I will see what I can do

BIG BOB 08-04-2013 08:51 PM

That was the problem. I used a paper clip to clean it out and it fits now. Thanks

All times are GMT -4. The time now is 12:44 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC