|CCM Chipley Machine|
| ||Thread Tools||Search this Thread|
|11-05-2013, 07:03 PM||#1 (permalink)|
Buying Bankruptcy Kits
Join Date: Sep 2011
Location: SoCal, USA
CCM inline reg not up to speed
Ok what am I doing wrong? Pulled apart the reg to see if anything is wrong as I can't get it to let my S5 shoot up to velocity. Everything is fine, o-rings, spring, piston, poppit, poppit spring, everything. Cleaned and re-lubed and still causing my marker to shoot below 200. Turning it in to increase pressure isn't causing any changes
"But Donut, are you sure it's the reg? what about the springing in the lower tube? Maybe your internals are bad?"
Same settings, swapped out the S5 reg with another reg I have up to speed. Shot @ 315fps.
I don't want my reg piston to end up like noclue's if I keep turning it in with no result
|11-06-2013, 02:04 AM||#4 (permalink)|
it's not brain science !
with the reg on the gun take the bottom half of the reg off and then air it up . Listen for any air coming out of the top where the pin is .
|11-06-2013, 01:57 PM||#5 (permalink)|
Just make yourself a reg tester.
Get a gauge that goes up to the output of your tank
Thread it on a cheap Ion duck bill.
Go to any shop that does repairs and u'll find these parts cheap
"Originally posted by Element Paintball@pbnation: you realize it would be easier to get a new wife than a new dc2."
My MCB Feedback
|11-08-2013, 09:06 AM||#8 (permalink)|
Yield and Overcome...
While getting the pressure set properly is important, it sounds like you are making changes to the pressure and not seeing any change in velocity.
This makes me suspect the reg may not be working properly. Fortunately, changing two orings tends to resolve most problems with CCM regs.
Have you changed out the reg orings?
|Thread Tools||Search this Thread|