Approx. CCM reg pressure?
Is there any way of telling the approximate pressure of the CCM reg (newest style milling, on S6's) based on number of turns from flush?
I know you can do this for palmers regs, but I know nothing for these.
I dont have a gauge port.
Flush is ~300-350 (ish)...kinda, I think.
Most CCMs I have seen are near flush plus a half turn or so in.
Flush is about 300.
|All times are GMT -4. The time now is 12:32 PM.|
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC