tjd10684's Pneu-Assist Sniper kits
This will be the sale thread but as promised I will be giving everyone a week to gather funds if necessary. This will also be a first come first serve basis to avoid playing favorites. They will be going on sale 9/2/13 at 6:00 PM eastern time and I will be looking at PM times to see who came first.
For this first week I will be answering any questions comments or concerns in this thread.
Now down to business. I have 4 of these to sell. 3 black handles and 1 white. The price will be set at 300.00 for that price you will get the all the items shown in the pdf below except the ram (also noted in drawing). You will also get a small tube of loctite 222ms and loctite 242, a small jar of the recommended lube called SuperLube, 3 extra lpr spacers, 2 lp hose top hats and 1 ft of lp hose (several colors available).
Also so you get the best product possible with the least hassle, I am offering to install these on your marker for free. You will send me your entire marker I will install time, tune, and test then send it back ready to go.
It is also of note that I would recommend using QEV's on your ram. I have successfully tested it without them but I did notice a marked improvement when I installed them.
Now please if you have any questions or concerns please post them here and I will do my best to answer them.
Thanks for looking
(Fit testing pic)
edit: damn, posted before reading that the fun doesn't start till next week.
Of course I'll be in upper Ontario on a Black Bear hunt when these go on sale where I will have absolutely NO INTERNET SERVICE, lol. Any chance I can pre-order one in advance, lol. I'll get you on the back side if and when I send you my CF Boomstick to freak bore(hehe). Maybe you'll have another few to sell by then
I would like to do that for ya but these are so limited I'm going to have to stick to my first come first serve. Sorry about that. hopefully I'll catch ya on the next round.
What, if any, parts would you consider to be the wear items on the kit? Would you foresee any issues with the handle wearing out?
Of course the orings would be considered wear items. The handle would be the second most likely candidate to wear out. I did try to design it in such a way though that particulate matter would be less likely to enter the handle and cause wear. You will notice that the vents are directly under the barrel to keep most of the debris out and also their is a non sealing oring on the back of the main guide rod that is there specifically to keep dirt out and reduce wear. I have also been beating the crap out of my prototype and still have not had any problems.
|All times are GMT -4. The time now is 12:28 PM.|
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC