mcarterbrown.com  

Reply
 
Thread Tools Search this Thread
Old 07-15-2019, 06:00 PM   #1 (permalink)
Post Whore
 
aggroman's Avatar
 
Join Date: Dec 2009

Aggro-mod: Magnetic trigger mod for 160R & 170R

Hey guys,

Iíve had my 170R for a week now, so it was due to go under the knife.

Iím not a big fan of spring returned triggers so I wanted to find a way to add a magnet.

<<<DISCLAIMER>>>
Attempt at your own risk, I take no responsibility for any damage you may cause to your trigger/marker by doing this mod.


1.) Start by removing the full trigger assembly from the frame.

2.) Remove the forward most screw in the trigger, this controls pre-travel. Since I like my trigger as far forward as possible losing this adjustment wasnít a big deal.

3.) Drill a 1/8Ē dia. hole from the top where you removed the screw. For a clean appearance make sure you donít drill all the way through the bottom side.

4.) Add a 1/8Ē dia. magnet to the hole you drilled. I epoxied mine in the flush with the top of the trigger. Youíll have to play around with this a bit. But somewhere between flush and a 1/16Ē recess should be perfect for most people.

5.) Allow epoxy to cure, then reassemble your marker.

6.) Fine tune your trigger to make use of the new magnet.

I am very happy with my personal results. I ended up with a significantly lighter, yet snappier pull that is much easier to walk.

I hope you guys find this mod/walk through helpful.

Thanks,

Brock
Attached Images
     
aggroman is offline   Reply With Quote
Old 07-15-2019, 06:05 PM   #2 (permalink)
Patient Zero
 
Tracker's Avatar
 
Join Date: Apr 2006
Location: Las Vegas NV
Send a message via Yahoo to Tracker Send a message via Skype™ to Tracker

CCM Fan
https://www.kjmagnetics.com/ for all your magnet buying needs.. you can even control the power of the magnet in addition the the size
__________________

^And i did it while wearing a helmetcam^ in 1080P HD if you need proof
Trackers feedback
Tracker is offline   Reply With Quote
Old 07-15-2019, 06:09 PM   #3 (permalink)
Post Whore
 
aggroman's Avatar
 
Join Date: Dec 2009

Thanks for tip! I’m just using standard 1/8” dia x 1/16” rare earth magnets stacked 3 high to fill the entire hole.
aggroman is offline   Reply With Quote
Reply

  mcarterbrown.com » Paintball » The Armory » Eclipse

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Forum Jump


All times are GMT -4. The time now is 11:08 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC