|commandoman ||02-18-2012 09:30 PM |
More problems with the Mini
Ok, so it was leaking down the barrel, I lubed the bolt, and the o-rings and I replaced the poppet with the current v3 version, and it STILL leaks? Any ideas? None of the O-Rings appear worn, do I just need to power it up and dry-fire it?
|edge814 ||02-18-2012 11:51 PM |
Umm first thing did you make sure to completely reset the poppett to seal it up. We also just had the same problem with a buddies mini and what I ended up doing was stripping the entire marker down and lubing all o-rings including the air transfer plate o-ring. Also even if an o-ring doesn't look worn it could still need replaced.
|moonweasel ||02-19-2012 07:05 AM |
Little piston thing in the noid is possibly sticking, happened to mine after it was sitting for too long. Can disassemble it carefully to free it, pretty sure there is a guide on PBN to do it, or from memory ( I may be thinking of something else here, it has been a while since I've held let alone tear down my mini) there may be a small opening on the underside of the noid big enough to fit a small allen key to give it a prod.
Vibration from just pulling the trigger enough times, with eyes off of course, might shake it loose too.
|All times are GMT -4. The time now is 06:07 AM. || |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC