-   Empire (
-   -   Axe pro + spring feed (

Bigtuana 11-05-2017 08:38 PM

Axe pro + spring feed
Would a trracer style spring feed fit directly onto a 2015+ axe pro? Such a thing would be very attractive to an individual like myself.

dano_____ 11-05-2017 08:41 PM

Trracer no, empire sniper yes.

punkncat 11-05-2017 09:06 PM

I totally like where you are going with this....

apoc4lypse 11-06-2017 10:14 AM

I'll be designing a springfeed for the Mini for my next batch of Pheeds. It should also work with the Axe. I think I can make it either index on the feedneck insert piece or just float above the breech, held in place on the barrel using two clamping rings.

Rusty Brass 11-06-2017 11:03 AM

Apoc4lypse - my vote is for the feedneck route. I'd love to slap one on a ULE mag.
Tuana - You could check out Nummech's empire springfeed adapters until Apoc has his ready to go. Think I have one of the feeds sitting in a box somewhere...
Nummech - Threaded feedneck boss adapters

apoc4lypse 11-17-2017 08:28 PM

Here's the version of the Mini SpringPheed that mounts on the feedneck insert. I had to make it taller than I'd've liked to clear the lip of the insert, but I'll experiment with bringing it farther down. It tightens to the insert via a set screw going through the back of the mount.

SomeGuyFromPitt 11-18-2017 05:24 PM

I like it. Just found your website. Nice work.

The spring feed with magnetic trap door is a sweet design to load.

I might have to check out one.

Is there a way to use the same spring feed on both a mini and phantom?

apoc4lypse 11-18-2017 07:27 PM

The tube itself is universal but you'd have to buy a different set of mounts and rings to work with the Phantom ($30).

Bigtuana 11-18-2017 10:13 PM

That looks pretty slick, APOC. I like that setup a lot.

Axel 11-18-2017 10:50 PM


All times are GMT -4. The time now is 09:13 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC