mcarterbrown.com

mcarterbrown.com (https://www.mcarterbrown.com/forums/)
-   Autocockers (https://www.mcarterbrown.com/forums/autocockers/)
-   -   What is the recommended pressure for a stock WGP inline reg on a 2k3 autococker? (https://www.mcarterbrown.com/forums/autocockers/120867-what-recommended-pressure-stock-wgp-inline-reg-2k3-autococker.html)

Garbageman705 05-22-2010 09:16 PM

What is the recommended pressure for a stock WGP inline reg on a 2k3 autococker?
 
Thanks!:old:

sdawg 05-23-2010 12:17 AM

300Psi is what the manual says, iirc, but you should sweet spot to find the optimal pressure.

pumpdevil 05-23-2010 03:54 AM

350psi is a good start. I sweetspotted mine at 400psi. Lower pressure could cause bad efficency. Hope this helps.

pump 05-25-2010 05:34 AM

i get good efficiency with 250psi
but yes sweet spot first

Garbageman705 05-25-2010 03:19 PM

I used to run mine at about 250-280 if i remember. I've been gone awhile so I forgot but my friend has a chrono that I can use to sweetspot so I'll try that. Thanks for the input.


All times are GMT -4. The time now is 05:05 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC