mcarterbrown.com

mcarterbrown.com (https://www.mcarterbrown.com/forums/)
-   Canada (https://www.mcarterbrown.com/forums/canada/)
-   -   Getting rid of a little flutter (https://www.mcarterbrown.com/forums/canada/125755-getting-rid-little-flutter.html)

Zerbob 06-30-2010 05:46 PM

Getting rid of a little flutter
 
Several months ago I picked up a Pro Lite from the States for pretty cheap (was like $30). It worked great until a few months ago when the bolt started to flutter when I shot. Instead of firing once, then returning behind the sear it would go two or three times before going to an uncocked position. Any ideas on how I could solve this would be appreciated.

Zerbob

Radar 07-01-2010 10:52 AM

It's most likely your sear and/or hammer. Check your sear to see if its rounded at the edge where it makes contact with the hammer, if so it needs to be replaced, and check the hammer where the sear rest's. The hammer should have a 90 deg. cut, if its worn it could look like a 70 deg. cut. Use a file to get it back to 90 deg. It should work for a little longer, but will also need to be replace in the near future. Good luck.


All times are GMT -4. The time now is 05:49 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC