mcarterbrown.com

mcarterbrown.com (https://www.mcarterbrown.com/forums/)
-   CCM (https://www.mcarterbrown.com/forums/ccm/)
-   -   CCM A/T help? (https://www.mcarterbrown.com/forums/ccm/207150-ccm-t-help.html)

TippmannFireman 07-02-2012 11:16 PM

CCM A/T help?
 
So, I have a CCM 86* thin frame, and a CCM A/T that I want to put together to make heaven on earth. I've read stuff about CCM frames having pins, or a ball+spring combo kinda like a Sheridan or old Autococker frame, but I have no idea what I need exactly. Here's what I have.

https://i1167.photobucket.com/albums/...r/P1000734.jpg
https://i1167.photobucket.com/albums/...r/P1000732.jpg
https://i1167.photobucket.com/albums/...r/P1000731.jpg
https://i1167.photobucket.com/albums/...r/P1000738.jpg
https://i1167.photobucket.com/albums/...r/P1000739.jpg

So, what do I need/need to do to make this work? Sorry if this is an extremely stupid question, but I'm new to CCM's/CCM parts. :p

Also, sorry for all the dust. :rolleyes:

canuckistani 07-02-2012 11:23 PM

When you put the AT arm in place, there's a tiny pin that drops in the little hole at the top of the frame. That's what keeps it in place. Other than that, the AT arm should hook up to the pump guide rod and that's about it.

CCMachinist 07-02-2012 11:51 PM

you need this screw only. no pins, no spring and ball.Your cam doesn't have a groove for the ball anyway. The screw will hold in the cam .The screw goes thru the lever into the pump rod and keeps the cam from coming out

CCM AT Cam/Lever/Screw Set - Pol Black - 7B0003 | eBay

TippmannFireman 07-03-2012 12:26 AM

I have the screw that goes into the pump rod. I'm sending the rod to jcurt tomorrow to have it drilled and tapped for it. I just have read stuff about pins and ball and springs, so I didn't know what mine needed. Thanks!

Talfuchre 07-03-2012 07:04 AM

If you really wanted the right cam - you would need to get a grooved cam to accept the ball and spring.

What Bill is saying is the Pump arm Screw will not allow the cam and arm assembly to come out when leaning it to the left.

Also - follow my manual and properly adjust the under travel screw. You will be fine.

TF


All times are GMT -4. The time now is 06:27 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC