Belsales Evolution 1994 Autococker - parts help
I need help from an Autococker expert!
After a long search I finally put my hands on an Evolution Autococker. She had been lying down in a closet for 20 years. Last week I convinced my friend to sell it to me. As I expected a full rebuild is necessary. But I could not find any consistent information about its specifications.
What do I need to change on it to put it back on its original configuration?
Thank you very much
Ravi's Paintball Place - The Evolution Autococker
A very similar gun is pictured in that article.
Looks pretty stock for an older Evo. Usually the trigger guards were not cut stock but it's appropriate for the time. Great find!
What a gem, looks stocked but I would question the bolt.
Appears to be early 95 model. I agree with sale2me about the bolt.
Most of the bolts I've seen on early model evos had knurled ends that matched the cocking rod knurking.
That looks like an sto bolt, but I could be wrong. Ram would have been a Wgp brass ram.
It was probably run on co2, so you'll need to add an hpr if you plan on running hpa instead.
Thank you guys! Very usefull info.
Do you have more info about the frame ? It should be a standard wgp?
I've found these pictures of two old evo bolts. Any ideas which one is right? https://images.tapatalk-cdn.com/15/11...e448c79742.jpg
The bolt in the top picture is a Belsales Evolution venturi bolt.
Correct frame for that model would have been a wgp pot metal frame. Later models also came with Wgp composite frames.
The Belsales "angry" .45 slide frame was an optional upgrade on later models as well.
The pictured frame could be the stock frame, as someone else mentioned.
Exacly the same anno Riot!
Wish I never sold. :(
|All times are GMT -4. The time now is 05:34 AM.|
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC