|Rare, Old Guns This is a catch all sale forum for pump, double action, or semi auto's built prior to 1995 Old Parts for these guns are also welcome here|
| ||Thread Tools||Search this Thread|
|12-07-2010, 02:31 PM||#12 (permalink)|
Join Date: Jul 2006
Location: Coventry R.I.
I usually shoot it with siphon, but I never chronoed it. there is no way to change the velocity accept to rotate the valve to the smaller holes.
If the valve was homemade it was done well. the hammer oring looks like the flat disk type used on VM, but I didnt remove it for fear of damaging it.
Its hard to tell if the hammer lightning was factory or done after as the quality of the whole gun is on the low side.
|12-07-2010, 03:07 PM||#13 (permalink)|
Join Date: May 2006
It actually looks like an old school high durometer bolt o ring for a VM-68. The slots of the S-4 hammers are not skinny like the vm-68 hammer oring washers. The traditional hammer oring washers don't fit on the S-4 hammer. It takes an actual black oring, but with running liquid, the oring ballons and shreds and can be the reason why the s-4s don't recock right. It makes sense that the S-4 you have would work because it has a tough hammer oring and it doesn't get shredded that easy.
Could you take a closer pic for the hammer/oring? You don't have to take the oring off. I just need a close up. Try turning off the flash on the camera
Last edited by infamoussmiley; 12-07-2010 at 07:30 PM.
|Thread Tools||Search this Thread|