Springs for Sheridans
I know I have seen a post somewhere about this before but I never saw an answer. My question is why can't or can you use nelson springs in a sheridan gun???:confused:
I know the rear cap/asa/rva would have to be drilled out and the cup seal might need something on it to keep the spring from dropping over it but aside from issues caused by the diameter of the springs what else??
This would be great for the strokers as the nel springs are softer, hence less effort/air pressure to cock the gun. It would also be an advantage on pumps to make the action smoother and make them easier to cock. I have some nel springs and a project sheridan but need to get a valve tool to try it. Anyone have any thoughts on this?
I've actually been toying with that idea myself for a while lately. I let you know how it turns out when I get around to it.
i've set one up using cocker springs
made a new rear cap and turned the id of the hammer bigger.
link below of the picture
Did it make a big differance in it??
night and day for semi conversion.makes it easier for higher volicity with out getting he spring to come close fully compressing like the stock ones do
Isn't it possible just to find weaker springs with the same diameter as the stock sheridan ones?
not a matter of weaker spring, it's more the factor of coils per inch.
more coils. longer spring for throw. tend to get spring bind right before you hit the correct velocity. hence with a bigger dia spring, rated at the same as stock spring, with less ciols per inch would not bind and give a great range of adjustment
|All times are GMT -4. The time now is 06:34 AM.|
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC