-   Tiberius Arms (
-   -   Idea for remote line (

skullcandy1993 11-28-2012 01:43 PM

Idea for remote line
So I run a T8, and I love my T8 over any T8.1 I have owned, but I have been toying with the idea for running it on a remote line.

So I came up with a plan for doing that and it goes a little something like this:

1. Cut a hole through the back of the grip
2. Install some custom macro line and air fittings to replace the nipple that goes into the mag from the regulator
3. Attach that macro line to a remote nipple that is fixed to the hole you cut at the back of the grip
4. If you remove the CO2 valves from the mags there is enough room for that new air lines.

Does anyone else think that this could work?

Has anyone else ever attempted something like this?

Does anyone else have another idea for me?

Nightstar 11-28-2012 03:51 PM

I'd considered something similar. I think it's possible if impractical. you might be able to find a banjo fitting with threading that matches the co2 nipple; check ASP.

Overlord319 11-28-2012 04:02 PM

Why not remove the relief valve and replace it with a nipple. If youregulate from the tank it works fine. I believe someone on here even had a parts list up for this.
Just seems as though molding the grip and valves would be a pain.

Nightstar 11-28-2012 04:04 PM

Using the existing CO2 port and regulator seems to me a more elegant solution. Frankly were I a field owner I wouldn't allow anyone to use a marker with defeated safety features.

Overlord319 11-28-2012 04:06 PM


skullcandy1993 11-28-2012 04:15 PM

Ya, I have seen that mod before, but I would rather not do it that way and lose the relief valve

Overlord319 11-28-2012 05:11 PM

You could build a release valve into the aparatus?

Havoc-paintballer 12-02-2012 11:43 PM

So you would be modifying both the gun and the mags so that they couldn't go back to normal? Hmm....

The standard remote option tho for a T8 is pretty dumb if you want to play mag fed.

What about slicing the mags down the middle, leaving the CO2 half (back half) of the mag permanently attached to the inside back of the grip and the front half of the mag (ball side) could be removable? The back half could then use a standard tiberius remote line adapter. Seems like a possibility that would lead to much lighter/smaller mags and a stable remote option. Easier said than done tho lol. If I had some spare magazines that I was willing to waste I'd be willing to try this mod myself lol.

skullcandy1993 12-03-2012 01:09 AM

the way i have it thought out in my head would make the only permanent modification the hole in the grip frame for the remote nipple. If you wanted to change it back you could just put the original nipple back in the reg and reattach the CO2 valve to the mag

slingshotted 12-03-2012 04:17 AM

too bad there is no way to extend the length of the ball side to make room for maybe 10rd with a stick feed adaption like agent smith did on the G2 top loader in front of the tiberius mag so the ball loader pushes it up after we load it? have a typical remote line adapter in place of the co2 chamber.

All times are GMT -4. The time now is 06:05 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC