-   WDP (
-   -   Got my first Angel... what the heck is it? (

super_stanchy 02-28-2013 08:35 PM

Got my first Angel... what the heck is it?
Traded a buddy for it....

Wanna know exactly what i got :D

I need a charger for it....
Orrrr I need a way to power it (new board?)

Is this the same kind of Angel that was pumped?
Is it as simple as slotting the trapdoor thing, putting the bolt into the other slot (where the battery is housed?) and then making a linkage to push it?

HyperU2 03-01-2013 12:20 AM

I was never an Angel guy but I wanna say Warped Sportz Dark Angel LCD just in case my opinion is right.

super_stanchy 03-01-2013 12:40 AM


Dark LCD 2000

found a charger at radio shack
held a charge for a few min and shot, no idea how to change anything in the board...
but she's a work in progress!

gainman 03-01-2013 01:22 PM

Its a 2k dark. The batteries in these things typically go bad so if it doesnt hold a charge its the battery is probably shot. Your options are to hunt for a replacement battery (expensive and possible another bad one), the cr123 mod (youll have to search for that one), or the pmr board mod (PMR BOARD MOD

Yes this is the type that was pumped. Just slot the breech so the bolt stem goes into the other tube (battery tube). Pull the plug out of the battery tube side in the front of the gun and adapt a pump kit to thread into there. Build the linkage to the pump.

The pmr board mod is the way to go as far as electronics. the solenoid plugs right in and you can run a 9v in the frame eliminating the battery.

Body is 2k dark. CCM feed neck, twisted VRA, and dye single frame. the frame is somewhat rare, you dont see them to often. dont know on the barrel

super_stanchy 03-01-2013 02:23 PM

Barrel said ACI i believe
it had a stock feedneck, but i just happened to have a ccm angel neck layin around :)

im talkin to sledneckforlife about a board and mounts, but i just got a message from pedropfo about a mount (thats what the title says, need to open it still)

i think i'll end up pumping it

the battery tube doesnt have any airflow, correct?

gainman 03-01-2013 03:08 PM

In the lcd model there is no airflow it's just a battery tube

super_stanchy 03-01-2013 03:14 PM


Originally Posted by gainman (Post 2640525)
In the lcd model there is no airflow it's just a battery tube


Talfuchre 03-01-2013 03:14 PM

That is odd.

LCD - 2000 Dark Angel - Warped Sports - Milled by WDP.

However, it would have come with a dual trigger - and someone put on a Single Trigger Dye Frame - and put the board from the Dual inside that.

Then - they took a 'twister' VRA (vertical Regulator adaptor) and a Twister reg and replaced the stock ones (which would have been blue - stock- and look just fine).

The ball detent is also non stock - but Angel Made.

I want to say that the barrel is an ACI 'nitestick'.

I am sure on everything but the barrel.


super_stanchy 03-01-2013 03:16 PM

barrel is goin in the parts bin... got a $10 CP back off ebay :D

im happy with the single trigger, its gonna be pumped

gotta figure out how to take the battery out, heck maybe i'll cut it up tonight

idk :D

Talfuchre 03-01-2013 03:25 PM

It slides out the back after removing the back plate - the bitch is getting the wiring harness back in once you replace it.

Oh - there is a switch that Angel came out with in 2001 installed on it as well.

Here is the manual.

Also - no one sells the battery any more - here is a mod to make one rechargeable.


All times are GMT -4. The time now is 02:16 AM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO
© MCB Network LLC