Welcome to MCB! If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I made these in the past (and a few different profile variations), i think they were for Alexndl , maybe he can chime in on how well they fit.
The right one i think you have to have a back plate to screw on? and the left one i think works without a backplate?
I made these in the past (and a few different profile variations), i think they were for Alexndl , maybe he can chime in on how well they fit.
I use them with the CCM back plate and they work well
not as smooth as a machined delrin piece bit its not far. Probably would get better with some light sanding on the inside with smooth sandpaper on a wood dowel.
I use them with the CCM back plate and they work well
not as smooth as a machined delrin piece bit its not far. Probably would get better with some light sanding on the inside with smooth sandpaper on a wood dowel.
Comment