instagram takipci satin al - instagram takipci satin al mobil odeme - takipci satin al

bahis siteleri - deneme bonusu - casino siteleri

bahis siteleri - kacak bahis - canli bahis

goldenbahis - makrobet - cepbahis

cratosslot - cratosslot giris - cratosslot

Announcement

Collapse
No announcement yet.

Hand Tightening Hammers?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Hand Tightening Hammers?

    Would it be advisable to leave the hammer on a b2k/PM hand tight with an oring at the bottom of the threads for preload, or would it vibrate loose?

    Sent from my Pixel 4a using Tapatalk


    #2
    My take on that idea is no, for two reasons... one, the hammer will loosen off in time and you will destroy the lower tube/valve/ram shaft/etc, and two, the oring will space the hammer out further than is designed and the bolt will not line up properly/the rammer may bottom out on the valve.

    Use a bit of blue loctite and you will be fine.

    Up to you, really.
    And God turned to Gabriel and said: “I shall create a land called Canada of outstanding natural beauty, with majestic mountains soaring with eagles, sparkling lakes abundant with bass and trout, forests full of elk and moose, and rivers stocked with salmon. I shall make the land rich in oil so the inhabitants prosper and call them Canadians, and they shall be praised as the friendliest of all people.”

    “But Lord,” asked Gabriel, “Is this not too generous to these Canadians?”

    And God replied, “Just wait and see the neighbors I shall inflict upon them."

    Comment


      #3
      Thanks Jordan, ya you're right, not the greatest idea. No matter how hard I try no to, I manage to Mar the ram shaft/hammer without fail. Just getting tired of repolishing them. If only they milled Allen key slots in them...

      Sent from my Pixel 4a using Tapatalk

      Comment

      Working...
      X