I've created a Shapeways shop for some of my designs. The page can be found here: https://www.shapeways.com/shops/3d-pb-designs
Individual prices are dependent on the materials selected (Please see site for specifics)
Emek / Etha 2 Bolt Cap
Easier to grasp to make unscrewing the bolt more convenient
Extended Sheridan Feed Plug
Takes two #015 o-rings to hold it in place (not included). Compatible with Sheridan stock class markers up to and including the PGP2. Also accepts stock Sheridan Allen screws to lock it into place (optional). This model also has a hole through it for an optional lanyard to tie it to the marker.
Offset Phantom Feed Cap for Drop-Out 12-Gram Changers
Raises the feedgate so that it does not need to be trimmed to reduce stress on the feed tube. Depending on printing tolerances, you may need to lightly sand the interior or add electrical tape to the end of the feed tube for a snug fit.
Nelspot 007 Pump handle
Pretty self explanatory
Hardpoint 12-Gram Holder
A bottomline mounted 12-gram holder that uses two o-rings to hold the cartridges in place (o-rings and screws not included)
Individual prices are dependent on the materials selected (Please see site for specifics)
Emek / Etha 2 Bolt Cap
Easier to grasp to make unscrewing the bolt more convenient
Extended Sheridan Feed Plug
Takes two #015 o-rings to hold it in place (not included). Compatible with Sheridan stock class markers up to and including the PGP2. Also accepts stock Sheridan Allen screws to lock it into place (optional). This model also has a hole through it for an optional lanyard to tie it to the marker.
Offset Phantom Feed Cap for Drop-Out 12-Gram Changers
Raises the feedgate so that it does not need to be trimmed to reduce stress on the feed tube. Depending on printing tolerances, you may need to lightly sand the interior or add electrical tape to the end of the feed tube for a snug fit.
Nelspot 007 Pump handle
Pretty self explanatory
Hardpoint 12-Gram Holder
A bottomline mounted 12-gram holder that uses two o-rings to hold the cartridges in place (o-rings and screws not included)
Comment