Announcement

Collapse
No announcement yet.

Replacing Carter Puncture Pin/Seal

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Replacing Carter Puncture Pin/Seal

    Hey all!

    I'm curious if the phantom puncture pin assemblies are compatible with the carter ones. Potentially looking to replace the one I have, if at least the puncture seal part. It's like a slightly rubbery/malleable red material. Had a 12 gram get stuck today (inside duck handle) and had to disassemble to get it out. Ones after were fine, but just wanted to potentially prevent this from happening in future.

    Thanks for your knowledge/insight!

    #2
    I can't say 100% but none of my Carter changers were.
    Need Inception Designs Products? Let me know!

    MCB Feedback

    old PBN feedback

    Comment


    • Lawn
      Lawn commented
      Editing a comment
      Thanks! I was assuming as well and I didn't want to try and disassemble to put one on just in case it might mess it up.. Sometimes we SHOULDN'T tinker..

    #3
    I am trying to remember, but one of them took like a faucet washer size and another took the same size as a PGP.
    Chances are your 12gram got stuck due to bad 12gram tolerances, not the seal. If it isn't leaking then don't worry about that.
    Need Inception Designs Products? Let me know!

    MCB Feedback

    old PBN feedback

    Comment

    Working...
    X