Got a PGP a while ago, which was missing the top tube for some reason.
Decided to go freaky.
The top tube is the perfect ID for freaks, so made a smaller ID tube that the delrin bolt runs in and creates a shoulder for the freak to butt up against.
Opened up the transfer hole to 5/16" and made a matching valve, just to see if I could.
It needs a bit of tweaking to the feed ramp on the plug to work consistently, but it'll get there.
The knurled freak tip (I was on a knurling rampage for some reason) is held in place by the feed tube nose cap screw, it runs right through to act as a set screw.
I strongly think may powdercoat, just not sure of the colour.
Decided to go freaky.
The top tube is the perfect ID for freaks, so made a smaller ID tube that the delrin bolt runs in and creates a shoulder for the freak to butt up against.
Opened up the transfer hole to 5/16" and made a matching valve, just to see if I could.
It needs a bit of tweaking to the feed ramp on the plug to work consistently, but it'll get there.
The knurled freak tip (I was on a knurling rampage for some reason) is held in place by the feed tube nose cap screw, it runs right through to act as a set screw.
I strongly think may powdercoat, just not sure of the colour.
Comment