Thread: Pgp bolt lug
View Single Post
Old 04-11-2012, 02:24 PM   #2 (permalink)
WALZ
MCB Member
 
WALZ's Avatar
 
Join Date: Nov 2010
Location: coarsegold,ca

Brass N Wood Fan
RTP Fan
The easy way is to remove pump arm- put end of rod back into bolt and twist it cockwise with bolt in fire position. Bolt pin should now be sticking out side of marker where it is notched out. There is a small slot for a small screwdriver in the tip of the pin. Remove with driver or small vice grips (carefully so you don't scratch marker). You can use a #8 set screw for as a new pin (screw it in so it just clears top of hammer. Hope this helps> If there is no slot for a flat driver then its a push in pin and just push it in firm and pull bolt out...
__________________
WALZ Feedback
WALZ is offline   Reply With Quote