View Single Post
Old 10-10-2012, 11:13 AM   #4 (permalink)
newmaticarsenal
Active Member
 
newmaticarsenal's Avatar
 
Join Date: Oct 2008

I don't own one. However, since the 3 holes are all in a line and this appears to be machined, not cast; the following stands to reason.
The top hole should run to the oblong #010 hole.
The Second hole down should run to the #007 hole.
The bottom hole should be a vent/ exhaust.
Otherwise the passages would cut into each other when drilled.
newmaticarsenal is offline   Reply With Quote