Thread: G10 45 panels
View Single Post
Old 06-10-2013, 08:01 PM   #3 (permalink)
CCMachinist
MCB Member
 
Join Date: Oct 2007

CCM Fan
The material machines ok . It is harder on tooling. The machine time is about the same as delrin.
here is some info:

G10 fiberglass boards are made of a special glass epoxy laminate that has extremely high strength. G10 fiberglass is used in marine applications due to its superior strength, moisture resistance, and excellent electrical and fire insulation.
Fiberglass boards make excellent non-corrosive backing plates for high load deck hardware or bond to engine room bulkheads to hold mounting brackets. G10 boards are sold in 1/4 and 1/2 inch thickness.

G-10 is similar in strength and density to starboard, but because it is formed from epoxy resin, it bonds easily using most two-part epoxies.
__________________
“Do not yearn too much for a sword made by a famous smith. This is because even if you give a good man a sword worth ten thousand coppers, he will not be able to beat a hundred men each holding a spear worth a hundred coppers.” - Asakura Takakage Toshikage, 1462-1482

Ecc. 9-10
Whatever your hand finds to do, do it with your might; for there is no work, nor device, nor knowledge, nor wisdom, in the grave, where you go.

DOOR GUNNER handgun mounts for gunsafes.

http://www.machineshopdpm.com/
CCMachinist is offline   Reply With Quote